Register and/ or login to remove this ad
This forum is for mechanically related posts; engine, drive train, and other mechanical components.
TIPS ON PUMPING GAS Only buy or fill up your car or truck in the early morning when the ground temperature is still cold. Remember that all...
Looking for some of these in smaller sizes. Anyone know where I can locate some? These are Synergy but they are bigger than I'm looking for. I'm...
i have a busted speedo cable in my 89 runner, and it has a 98 taco engine with a OBD2 port... can i use a scangauge/ultragauge to still give me a...
I found 3 different ones that I am considering for my HA install. 2 are relatively close in price and the 3rd is a little more. Looks like a good...
I'm planning on pulling the ADD out of my '01 Taco and swapping it with the manual hubs/diff that is currently in my '98. ...
Haven't dived into this project before. How difficult is it too replace the carrier bearing on these 2nd Gen tacos? Any advice is much appreciated
I know I couldn't find all the specs on these when I was looking so now that I have them in hand, here they are. 2005-2011 Toyota Tacoma Wheel...
Ok, I have given up on the useless forum..... I came to the real experts. So my issue is that I am pretty sure that the pinion seal on my truck...
I met "Bloc" this weekend while swapping my 3.73 elocker for a 4.10 elocker he had picked up. He brought his diesel 4runner and I got to check it...
So I decided to relocate the T-case vent up into my engine bay today. This was very simple and took about 10 minutes in total. After driving through...
I feel like a total newb asking this.... I have been looking for brake pads for my V-6 IFS caliper and vented rotor swap. Are the brake pads...
:eek:
I have been looking for the size of the nut that holds the output flange on my trans case. I know its pretty close to a 1 1/4 in but that is just...
Calling out for help / advice... How in the hell do I get the inner and outer bearing races out of my hubs
I searched around in here and noticed we didn't have anything so here is my attempt at stealing and piecing some info together I found. Wheels are...
I went wheeling with a friend yesterday with a friend that had a ripped boot on both of his trucks - I was thinking one of these would be good for a...
Okay, so I have been very lucky so far but it is time for me to get some gussets on my front end - I tweaked them out in the desert a couple of trips...
Well, I keep going back and forth about which axle I want to run.......I go from anting a 60 to wanting a 44 to wanting a hybrid axle. I was set...
I thought I would put the references here so that if and when you do yours it will be in one place. Components and Disassembly...
http://www.dieseltoyz.com/2005_tacomadc.html hmmm, despite the injector issues Toyota is having with the 1KD-FTV, I would sell my testicals to...
I just purchased a 06 Tacoma reg cab prerunner 4cyl 5spd. When I shift into 4th gear at lower RPM and under load, there is this loud rattling,...
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules
