New member in idaho springs, Colorado

[Silverback]

Must be nice to have a boxed frame. Just looking at the differences in the pic.

Also just spotted a potential issue with my build and those same shocks. My bumper reinforcement goes back to the rectangular hole that's in between the remote resi and the shock tower then sandwiches the frame there. I hope my bumper bracket clears that resi and mount.

It won't.. I had to modify mine.

 

[Anathollo]

Interested to see how this set works out. The Tacoma that I just put new pads and rotors on is shimming pretty bad already. I need to get in there and see why.

You probably have a seized piston in one of your calipers.

 

[tx_shooter]

You probably have a seized piston in one of your calipers.

That would make sense. I drove it less than a week prior and it was completely fine. Then the following week it shimmies on the passenger front like the tire only had two lug nuts on it.

 

[Anathollo]

That would make sense. I drove it less than a week prior and it was completely fine. Then the following week it shimmies on the passenger front like the tire only had two lug nuts on it.

If that's the case, don't get the rebuild kit. It ain't worth it, you need like three sets of kids hands to hold the snap ring, put the rubber grommet on and align everything. Just buy a new caliper and call it a day. It took 4 hours with my step-dad's help and two full rebuild kits to "re-build" one side (2 pistons) of my OEM calipers.

 

[Oswego]

It won't.. I had to modify mine.

Won't fit? Mine looks like this - it's a pretty big bracket. Still think it will fit? Not that it really matters - Ill make it fit.

 

[Silverback]

Mine bumper supports go back further. You might be ok. I had to notch mine reservoir mounts.