Red's 01 4Runner

[tx_shooter]

Or @SamSter0077

He is pretty versed on tearing up IFS Toyoats.

 

[Mauzer]

Or @SamSter0077

He is pretty versed on tearing up IFS Toyoats.

True!

 

[taco4x4rar]

If your legit shearing pinions and it's not due to poor gear setup or twisted mounts, then there isn't much you can do short of swapping a bigger diff or an axle swap

 

[Silverback]

Holy SHIT.. Randy is alive!!!

 

[Large]

If your legit shearing pinions and it's not due to poor gear setup or twisted mounts, then there isn't much you can do short of swapping a bigger diff or an axle swap

It was just odd to me.. I have a new diff from ECGS and I'm gonna try to make sure everything is right when it gets installed .. then again @Snorkie and I swapped the last one in 20 deg weather and we were pretty buzzed so not sure if the diff is the culprit. I think it's the t-case.

 

[tx_shooter]

If wrenching with a buzz is bad then everything on my 4runner is suspect. @Silverback is fucked.

 

[Large]

If wrenching with a buzz is bad then everything on my 4runner is suspect. @Silverback is fucked.

That applies to all my vehicles plus a few more rolling around that aren't mine

 

[Anathollo]

If wrenching with a buzz is bad then everything on my 4runner is suspect. @Silverback is fucked.

Wait...you wrench SOBER??? WTF?!

 

[SamSter0077]

hey Randy! did you do the diff drop in the front? I haven't blown any diffs since sending a box of parts to Zuk.

 

[Large]

Picked these up from an old ‘friend’ going to make some progress this weekend with the front I hope.

 

[balakay]

View attachment 10867

Picked these up from an old ‘friend’ going to make some progress this weekend with the front I hope.

Did those come from where I think they did?

 

[Large]

Did those come from where I think they did?

Well you can message whoever you think they are from and find out.

 

[Boomtacoma01]

Looks good man

 

[Large]

Old diff on left
New on right with ARB

Gears coming out of the ADD side of the diff on the old diff - do they need to go on the new diff? Or did the ARB eliminate something? Just don’t see how it will shift to 4wd without them ..

 

[Large]

Nvm I got it, swapping it to the new diff

 

[tx_shooter]

Yep - need those to go 4wd.

 

[Large]

Break time! Figured I need some stitches.

 

[tx_shooter]

Supposed to keep the red stuff on the inside. Looks like that CV axle is going to have to wait a bit.

 

[Large]

Driver side done so far, no the 35 mm isn’t torqued yet.

 

[Large]

Wrong pic in above post, this is the right one.