What have you done to your ride lately?
- Thread starter jdmcq
- Start date
Silverback
Lima Gulf Bravo Foxtrot Juliet Bravo
Finally installed the bumper supports that tie back to the frame. It required reworking my remote resi mounts... so I just built new resi mounts and added them to the bumper supports. Turned out really clean not to mention much stronger than the thin sheetmetal resi supports I had. I still need to drill two holes for some extra 1/2 bolts... tomorrows project.
TacoXpo
HOAX DENIER
pics or it didn't happen.
Silverback
Lima Gulf Bravo Foxtrot Juliet Bravo
Shot is helping but I'm still in a bit of pain. Actually going to see the spine Dr again today to discuss next steps.
texasislandboy
donde esta la NGAGE IT
Ordered a electric fan setup for the samurai... I need to get all the power I can get.... This 1.3L is S L O W
texasislandboy
donde esta la NGAGE IT
Amazon electric fan....
Finished an oil and diff fluid change on the DD. From the smell of it I am a little late.
Silverback
Lima Gulf Bravo Foxtrot Juliet Bravo
$2 worth of hardware and my toolbox is fixed. I replaced both sides with new bolts, lock washers, and nuts.
Shit man, that's 120 horse of stickers! You better watch that right foot
Working on the trail rig now. Exhaust is mounted and I am currently rebuilding the cross member. All the fun of a rig.
Shhhiittt, that's only one side. I get at least double that.
Glad that box is still working for you
Silverback
Lima Gulf Bravo Foxtrot Juliet Bravo
Added the extra 1/2" bolts to the bumper supports.
thekidcatcher
Well-Known Member
Nothing to my truck but I dumped the exhaust on the bronco over the axle. Also fixed some side panel stuff with Hopadillo beer cans and self tapping screws. Tightened up the exhaust too
texasislandboy
donde esta la NGAGE IT
painted the samurai today. Flat Tan... Almost done with it should be tomorrow.
thekidcatcher
Well-Known Member
Ill get the cardboard for zebra stripes 
texasislandboy
donde esta la NGAGE IT
haha I think this is gonna stay one color ha
Boomtacoma01
Tommy want wingy..
Got my new pads and rotors finished up this morning. Had too much vodka last night so I had to finish up this morning. Also greased front and rear drivelines.
Also discovered I may need a new carrier bearing on the rear drive shaft.
Sent from my SPH-L710 using Tapatalk
Also discovered I may need a new carrier bearing on the rear drive shaft.
Sent from my SPH-L710 using Tapatalk
Last edited: