taco4x4rar
Well-Known Member
Sorry I wouldn't have the balls to test that
Tools!
- Thread starter Silverback
- Start date
Sorry I wouldn't have the balls to test that
yotarob
Kiss My IFS
It was tested in a very controlled manner, you don't just jam your finger in there and hope it works. We set the fence up on the saw to where it would be cutting about 1/16" off of a 4" strip of plywood. My buddy who bought the saw put his finger right on the edge of the plywood, to where he only stood to loose about a 1/16" of the side of his finger and went for it slowly. The saw stopped instantly. He runs a cabinet and trim business and had 4 table saws that all worked fine. He bought 1 saw stop saw and was considering replacing all of his saws with them, but at over $2000 each he needed to be sure that it worked. He now has 3 and still plans to buy a 4th.
bakerla
Man, Myth, Legend
Taco Loco
Tired and Lazy, married to ‘The Laundry Fairy’
Your garage is filling up fast, time to knock out the back wall towards the den and extend it....
Baker, I sold my boat a few years ago, because the kids were too young and it only gets harder to escape the house. About 2 years from now I'll buy another center console because they will be big enough and should be proficient to swim, the youngest will be 6 then. My old man still has a shallow water running boat though. I hope you get to use it more than I was thinking....
Nothing is funner than hooking up on a big fish having it pull you around in the kayak in the bay system...
bakerla
Man, Myth, Legend
tell me about it, ive got some reorganizing to do to clean up some of the clutter.
Taco Loco
Tired and Lazy, married to ‘The Laundry Fairy’
Last edited:
taco4x4rar
Well-Known Member
Longevity, they are the right price and they have a good rep on pirate and welding web. I've got one and like it a lot.
TacoXpo
HOAX DENIER
Cool - thanks!
What model do you have?
They outfitted our Welding Lab at ASU... I just assume I had bias!
taco4x4rar
Well-Known Member
Cool - thanks!
What model do you have?
They outfitted our Welding Lab at ASU... I just assume I had bias!
The model I have isn't made anymore but it's the equivalent of the LP-60D, same machine really but the old version I have requires much more input amperage than the new one but has the same specs and duty cycle.
Northern tool has them as well.
balakay
BabyMax
Yeah but they're $750 and I only have $50 worth of NT discounts. Plus TSC is only about 5 minutes from the house.
Cool. Just throwing that out there that they had them.
texasislandboy
donde esta la NGAGE IT
you know I spent about 200$ on the cord and plug for my welder and I wish I would have got a longer cord....
balakay
BabyMax
I have everything already except the female plug for the cord. Wires are already run and everything. Just have to add the plug.
texasislandboy
donde esta la NGAGE IT
nice!
balakay
BabyMax
Yeah we have a 220v for our stick welder but it's wired directly to the welder instead of a plug.
Silverback
Lima Gulf Bravo Foxtrot Juliet Bravo
I bought a welding extension cord from Northern Tool. got a great deal on it.. $50. http://www.northerntool.com/shop/to...Safety&mkwid=s4ZInD2yQ&pcrid=15682114391&mt=b
Just wish it was a LITTLE bit longer.. to reach out into the driveway more.
Just wish it was a LITTLE bit longer.. to reach out into the driveway more.